Fluid Advance Work Support, hydraulic pressure pushes a spring
which lifts plunger; hydraulic pressure locks in place.
4,4 - 26,7
23 x 33,5 x 44,5
31,5 x 41,5 x 58,5
26,5 - 53,5
25 x 73 x 81
* Support capacities are listed at 350 bar (35 MPa) maximum operating pressure. Support capacities for other pressures must be determined by consulting the Capacity Charts.
* Restrict the flow rate to a maximum of 2,13 L/min.
** Minimum fluid pressure 36 bar (3,6 MPa).
*** DIN ISO 2768 T1 and T2 not applicable.
**** The maximum system back-pressure a fluid advance work support can overcome is
0,7 bar (0,07 MPa). Returning back-pressure greater than 0,7 bar (0,07 MPa) may cause
slow or failed retraction.
For minimum operating pressure and resulting capacities see Capacity Charts.
For Retracted Plunger Applications, Includes New Long Stroke Models
100% stainless steel plunger and sleeve assemblies help guard against corrosion in most machining environments.
Internally vented plunger gives air trapped between the hydraulic advance piston and the support plunger a place to escape, even when you install a custom contact point. (Note: Heavy end effectors/contact points are not recommended.)
Standard G Series porting and alternate O-ring manifold face seal is located in the base of the support for bolt down installation. The base can be removed for direct cartridge mounting.
All Dimensions are in mm.
NOTE: DIN ISO 2768 T1 and T2 not applicable
* Dimension "U" applies to models 41-0070-04 and 41-0070-14 only.
** All models have one manifold mount pressure port that is plugged at assembly. Refer to drawing ILMV100706 for the manifold mount pressure port location. For manifold mounting, remove the port plug and install the o-ring (provided) at final installation.
Cavity Dimensions Model No. 41-0071-04
Cavity Dimensions Model No. 41-0071-03
Cavity Dimensions Model No. 41-0071-02
Fluid Advance Supports, hydraulic pressure lifts spring which lifts plunger, hydraulic pressure locks.
(6 x 1.5 mm)
( 7,65 x 1,63 mm)
(9,25 x 1,78)