Metric

WARNING: Never allow swing arm to contact workpiece or fixture during rotation.

Cylinder capacities are listed at 350 bar (35 MPa) maximum operating pressure with a standard VektorFlo^® arm installed. See the Arm Length and Pressure Limitations graph for clamping force with various other arm lengths installed.  The clamping force is adjustable by varying the hydraulic system pressure. To determine the approximate output force for your application, divide the cylinder capacity from the graph by 350 (35 MPa), and multiply the Resultant Number times Your System Operating Pressure to obtain the approximate clamping force for your application. Actual force will vary slightly due to internal cantilever loading, friction loss and/or return springs.

** To allow for piece part height variations, it is recommended that the vertical travel be set at about 50% of the vertical stroke.

NOTE: To insure maximum service life and trouble-free operation, restrict fluid flow to the level indicated in the Clamp Time and Fluid Flow Rate chart.

• Easy to use, just bolt in place and plumb or use
  the easy-to-make manifold pattern to eliminate external plumbing.
• Available in capacities from 2 kN to 11,6 kN at 350 bar (35 MPa) pressure.
• Can be either manifold mounted or standard plumbed using standard fittings
• Single piece body and mounting give a rigid installation, no threads to rock around or additional mounting hardware to buy.
• See metric Clamp Time and Fluid Rate charts for time and rates to avoid cylinder damage and
  preserve warranty.
• Standard Metric Arm Clocking feature uses standard Vektek Arms
• Arms sold separately .

Low installed clamping height can be fine tuned to fit your part.

U. S. Patent Nos.
5,820,118
6,886,820 B1

For proper sealing, the mating surface
must be flat within 0.08 mm with a
maximum surface roughness of 1,6 mµ R_a

All dimensions are in mm.